Revision 3.1
WebRelay
TM
Users Manual
Step 5: Before making any changes to the network settings, write down the current settings so that they
can be restored once WebRelay
TM
is configured. Next, select the radio button labeled “Use the following IP
address,” and type in the IP address 192.168.1.50. Type in a subnet mask of 255.255.255.0. Leave the
default gateway field blank. Click OK to apply the new settings.
2.3.3 Open Configuration Web Page
Once the network is set up, open the configuration setup page by typing the following URL into the
browser: http://192.168.1.2/setup.html (note that if option 1 above was used for initial configuration,
replace the IP address given here with the newly assigned IP address). A password is required to change
any parameters. The default password is ‘webrelay’ (do not include quotes, password is case sensitive).
2.4 Web-Based Setup
WebRelay
TM
is fully configurable through HTML 4.0 compliant web browsers such as Internet Explorer and Mozilla
Firefox. It’s easy to use tab based menu system has been designed to allow the unit to be configured easily. Note
that in this chapter, the default IP address of 192.168.1.2 is used in all examples. If the IP address has been changed,
substitute the new IP address for the address shown in the examples.
Before proceeding, make sure a network connection has been established between the computer and WebRelay
TM
.
This is done by typing the following URL into the web browser: http://192.168.1.2/setup.html. Another way to
check communications is to ping WebRelay
TM
(from the command prompt (type ping 192.168.1.2)). Each setup page
is described below.
2.4.1 Main Setup Page
This is the initial page that appears when the URL http://192.168.1.2/setup.html is entered into the web
browser. It provides basic information about the WebRelay
TM
unit. Navigating between setup pages is done
by clicking on the tabs at the top of the page.
Xytronix Research & Design, Inc.
page 21