Getting Started
Charging your Jump Starter
1. Please use a 5V2A/9V2A/12V1.5A
adapter to charge the product.(Type C
cable is included, adapter is not
included)
2. Using a 5V/2A adaptor, it will take
approximately 5-6 hours to fully
charge the unit. In order to extend the
battery life it is recommended to fully
charge the unit every 3-6 months.
Turn On your Jump Starter
Short press the power switch to boot the jump starter, the display will be
turned on. For energy saving, the jump starter will be turned to standby
mode if there is no operation within 20 seconds.
LED Light
Turn on the jump starter. Long press the power switch more than 3
seconds to turn on the flashlight mode. There are four modes including
illumination, SOS and Strobe, warning light. Short press the power switch
button to change the 3modes(illumination, SOS and Strobe) or turn off the
flashlight mode. Double press the power switch button to enter the warning
light mode or turn off the warning light mode.
QC3.0 & 5V 2.4A Dual USB Output
This portable jump starter is also equipped with two smart USB outputs
that provide the fastest charging speed(USB1 - QC3.0
:
5V 3A / 9V 2A /12V
1.5A; USB2 - 5V 2.4A) for your portable electronic devices, such as
phones,tablets, bluetooth earphones, etc
（
adapter is not included
）
support@ibuture.com
support@yaberauto.com
EN
04
