![background image](http://html1.mh-extra.com/html/yacht-devices/ydeg-04/ydeg-04_user-manual_3081541032.webp)
— 32 —
To simplify obtaining the calibration string, we prepared an Excel file available on our
You only need to specify your gauge's readings and the measured remaining fuel volume to get
the calculated calibration string.
18. EXHAUST_TEMP=ON|OFF
Factory setting: ON
Allows or denies transmission of exhaust gas temperature. Legacy chart plotters may not show this data.
19. BRP_ROTAX=ON|OFF|HANDSHAKE
Factory setting: OFF
Turn on/off the support of BRP CAN protocol, used in Bombardier Recreational Products engines,
e.g. Rotax 1503. The HANDSHAKE setting may help with some old engines if fuel rate and some other data
are not available. Note that most BRP engines use 500 kbps CAN speed and some engines use 250 kbps
speed (see the next setting).
20. ENGINE_CAN_SPEED=50|125|250|500
Factory setting: 250
Switch the speed of engine network interface between 250 kbps (default setting used in Volvo Penta
EVC, SmartCraft and J1939 engines), 500 kbps (used in most of BRP CAN engines), 50 and 125 kbps
(experimental, no practical application). Note that the device must be rebooted for the change to take effect.
21. VOLCANO=ON|OFF
Factory setting: OFF
This setting is required on Gateways connected to the C4:MULTISENSOR (yellow) or C5:ENGINE (grey)
ports of an EVC-A MC (EVCmc) system only. Please see IV.1.4 for details.