— 14 —
2. Connection to NMEA 2000
The Device should be connected to the NMEA 2000 network backbone with a NMEA 2000 drop cable (not
supplied with the Device). The Device is equipped with a DeviceNet Micro Male connector. For NMEA
2000 networks with other connector types, you will need an appropriate adapter cable.
Before connecting the Device, turn off the bus power supply. If you have any questions regarding the use of
connecting cables, terminators or connectors, please refer to the following documents:
•
• SeaTalk NG Reference Manual (81300-1) for Raymarine networks.
After connecting the Device, close the lock on the connector to ensure its water resistance and reliability.
The Device is powered from the NMEA 2000 network and has LEDs, which flash red or green. After the
NMEA 2000 network power is turned on, the status LED (labeled “N2K”) should produce one long and
three short green flashes. If this does not happen, refer to Appendix A.
You can also check the NMEA 2000 connection and firmware version from a chart plotter. The Device
information including the firmware version is displayed in the list of NMEA 2000 devices (SeaTalk NG,
SimNet, Furuno CAN) or in the common list of external devices on the chart plotter. Usually, access to this
list is in the «Diagnostics», «External Interfaces» or the «External devices» menu entry of the chart plotter.
Technical Reference for Garmin NMEA 2000 Products (190-00891-00)
for standard NMEA 2000 networks;
Summary of Contents for YDTA-04N
