Page 31 of 45
4.2.5.
Switch Station
The web pages under the menu item 'Switch Station' allow the user a port to port configuration of the
switch, the RSTP configuration and the possibility of a software-induced reboot (soft reboot).
Services
The website 'services' allows the user to reboot the switch. By clicking on 'reboot' to start the switch in
the last saved configuration, or the factory state.
Figure 4.13.: Website ’Services’
Ports
This website allows the user to configure the switch for the Ethernet network port by port.
The Port Table Port Table displays the status of each Port, which was set in the port configuration table,
see section 4.2.5.
• Port:
The port number
•
Type:
TX 10/100 for 10BASE-T or 100BASE-TX,
•
Port Status:
The port is active or not active. In addition, the voltage and temperature are displayed in
FX
ports.
•
Link Status:
Connected or disconnected. If connected, the transmission and duplex mode are
displayed:
10/100 full duplex (FD) or Half Duplex mode (HD).
Figure 4.14.: Website ’Port Table´
