3
1. CMOS Sensor
2. Operating Voltage: DC 12V / 24V
3. Operating Temperature: -10~+50°C
4. Night vision
5. 110 Degree View Angle
6. Camera Water Resistance: IP67 rating
DASH MONITOR INSTALLATION
1. Take the monitor out of the box and clip directly into a vent on your dash board. The vent mount
is already attached to the monitor, but can be removed if needed.
2. Now power the monitor:
a. 12V/24V Power Adapter
Take the 12V/24V Power Adapter and plug adapter into the right side of the Yada Dash
Monitor. Plug the other end into 12V/24V power port in your car.
b. Hard wire
Take the Hard Wire Power Adapter and plug adapter into the right side of the Yada Dash
Monitor. Run cable to fuse box and connect to fused accessory power source. Refer to
your vehicle owner manual for location of available accessory fuses.
3. At this time, the Yada Dash Monitor is ready to be automatically powered on when the vehicle
engine starts.
Warning: Many vehicles provide constant power to the 12V outlet. If your outlet provides constant
power, please remember to unplug the monitor when not in use to avoid draining the vehicle
battery.
3. PRODUCT SPECIFICATIONS
4. INSTALLATION GUIDE
Summary of Contents for BT55496
Page 1: ...BT55496 BehindSight TM Wired...
Page 18: ...BT55496 BehindSight TM c bl GUIDE D UTILISATION GUIDE D UTILISATION...
Page 34: ...32...
Page 35: ...33...