Frame & Chassis
36
Steering Stem
Ś
ś
Ŝ
ŝ
Ş
ş
Š
š
• Handle
→
Page 38
• Front shock Absorber
→
Page 34
• Remove the lock nut
1
• Remove the check washer
2
• Remove the upper gear
3
• Inspection: Whether the upper steering bearing
4
and the lower steering bearing
7
are
damaged, (falling steel balls or rust and damage to the support base, etc.)
→
replace
Whether the upper and lower steel bowls
56
and upper and lower
gears
78
are damaged, (rust, cracks, damage, etc.)
→
replace
Whether the butter is aging or polluted (black)
→
replace
• After confirming that the parts are intact, raise the front shock absorber assembly and tighten the lock nut
1
• Check the rotation flexibility, if not flexible
→
Loosen the lock nut
1
to adjust to flexible steering, and the directional
device does not jump up and down.
• Install check washer
2
• Tighten the lock nut
1
(Torque: 75N~85N)
• Check the rotation flexibility again: if not flexible
→
Loosen the lock nut
1
, adjust the upper gear
3
, tighten the
lock nut
1
, adjust to flexible steering, and the directional device does not jump up and down. After confirming the
flexibility, tighten the upper gear reversely
3
(torque: 75N~85N).
Summary of Contents for C1S
