ATTENTION
●
Please keep it in the middle of the seat cushion. If it is too
forward or backward, the load ratio of front and rear wheels
will change, causing the handle to vibrate and causing danger.
1.Whether the tire pressure is normal. According to the
depression of the tire grounding part, judge whether
the air pressure is appropriate. If the air pressure is
abnormal, check it with a tire measure. Generally
speaking, the front wheels of ordinary tires are 175±5kpa
and the rear wheels are 200±5kpa. Vacuum tire: front
and rear wheels 250±5kpa.
2.Whether the tire is cracked or abnormally worn.
3.Whether the tire is embedded with nails, stones and glass.
4.When the tire is used to the tread wear mark, the
tire should be replaced.
1.Check whether the rear-view mirror is dirt or damage,
keep the mirror clean, replace it in time if it is damaged.
2.From the driver's position, observe whether the
rear-view mirror can see the rear and side road
conditions respectively.
1.Insert the key into the electric door lock, turn the power
switch clockwise to turn on the whole vehicle circuit.
2.Check power supply and lighting circuit. The front
and rear brake system. Reflector, license light.
Handlebar and front and rear wheel. Parts such as
tires ensure that there is no abnormality in the scooter.
3.Hold the handlebars with both hands, stabilize the
scooter hit the main support or the side support to
make the rear wheel land, support the ground with
the left foot and place the right foot in the pedal
position. After you are seated on the scooter, slowly
rotate the speed control knob counterclockwise inward,
and the scooter will start to run.
You can use the throttle to adjust acceleration or
deceleration to control scooter speed. Turn the throttle
counterclockwise inward, and the speed will change
from slow to fast. On the contrary, the speed will slow
down from fast. After loosening, the throttle will
automatically reset and the motor will stop working.
25
26
Correct driving
Start and driving
Speed adjustment
Inspection of tire
Inspection of rear-view mirror
Summary of Contents for V7
Page 1: ...USER MANUAL V1 0...