DANGEROUS
●
If the insertion part of the fuse is loose, it can cause the fuse
to heat up and cause accidents.
●
When replacing fuses, be sure to use fuses of specified
models and specifications.
●
If a fuse exceeding the specified capacity is used, it will cause
the main line to heat up or burn out.
●
If the fuse blows immediately after replacement, reasons
other than the fuse should be considered. The reason should
be found out and a new fuse should be replaced after adjustment.
●
When cleaning the scooter, pay attention to prevent
strong water flow from hitting the fuse tube.
1.When lights and signal lamps burn down, please go to
the distribution unit for inspection, repair or replacement.
2.Do not replace bulbs above rated power.
3.After replacing the headlamp, adjust the headlamp
beam if necessary.
Brake fluid: DOT 3 or DOT4
Disc brake plate
Lower pump
Upper pump(liquid level window)
Air vent
Wear marker boss
Brake pad
Wear marker groove
High liquid lever
Low liquid lever
Oil tube
Brake lever
Replacement of lamps
Turn off the power supply and check whether the fuse
is in good condition. If the fuse opens, replace it immediately.
1.Pull out fuse box
2.Open the fuse box, take down the fuse and replace
the same model fuse.
Replacement of fuse
When brake fluid is insufficient, air will enter the brake
system, causing brake to malfunction. Centralize the
scooter to keep the pump on the disc brake level and
check the liquid level in brake. If the liquid level is too low,
the brake pad is worn or the brake system leaks. Please
go to YADEA authorized service station for inspection
and maintenance. Add brake fluid or replace brake pads,
please use the same model.
43
44
Adjustment of disc brake
Summary of Contents for V7
Page 1: ...USER MANUAL V1 0...
