11
Communications (Data communication with the FTM-200DR/DE)
Get Data from SD card
This command imports the settings data from the microSD memory card to the ADMS-15 PC program-
mer, and creates a new data file.
1. Insert the microSD memory card with the saved data from FTM-200DR/DE to the computer.
2. Click [
Get Data from SD card
] in the “
Communications
” menu, then select the data area to read
from the following.
ALL
/
MEMORY
/
SETUP
3.
Select the file in the following folder of the microSD card drive according to the selected area.
ALL :
“
CLNFTM200D.dat
” file in the “
FTM-200D
” folder - “
BACKUP
” folder
MEMORY :
“
MEMFTM200D.dat
” file in the “
FTM-200D_MEMORY-CH
” folder
SETUP :
“
SYSFTM200D.dat
” file in the “
FTM-200D
” folder - “
BACKUP
” folder
4. Click [
Open
].
5. Click [
OK
].
When the data transfer is complete, the template screen which was imported from the FTM-200DR/DE
via the microSD memory card will appear on the ADMS-15 screen.
This template and configuration data may be saved to the computer hard drive, using the “Save”
or “Save as” commands in the “File” menu.
●The folder configuration of the micro-SD card
The parameters of each function are stored in the following folders.
(root)
FTM200D
GPSLOG: GPS Log data (yymmddhhmmss.log)
FTM200D_MEMORY-CH: Memory channel data (MEMFTM200D.dat) : MEMORY
PHOTO: image data (M+(RADIO ID)+xxxxx.jpg)
QSOLOG: Message data
VOICE: Voice recording data (yymmddhhmmss.wav)
BACKUP: Various settings data
(CLNFTM200D.dat) : ALL
(SYSFTM200D.dat) : SETUP
