About the setting items of each memory channels
• Receive Frequency/ Transmit Frequency
Enter the desired receive/transmit frequency. When the frequency entry is complete, use the → key to
move the cursor to the right and subsequently configure the additional detail settings for the channel. To
enter the transmit frequency for the next channel, press the ENTER or ↓ key. The receive and transmit
frequencies can be set separately.
•
Offset Frequency
When a transmit frequency is not entered, transmission will be performed at a frequency obtained by
adding/subtracting the offset frequency to/from the receive frequency.
•
Offset Direction
Set the frequency shift direction.
OFF:
The transmit frequency is not shifted.
-RPT:
The transmit frequency is shifted to the minus offset.
+RPT:
The transmit frequency is shifted to the plus offset.
-/+
The transmit frequency is not shifted.
• Operating Mode
Select the operating mode for receive channel.
FM:
The selected frequency band is set to FM mode.
AM:
The selected frequency band is set to AM mode.
• DIG/ANALOG
The AMS, V/D mode (DN), the Voice FR mode (VW) and the ANALOG mode (FM/AM mode) are select-
able.
When the Setup Menu [14 DIGITAL VW] is set to “ON”, the Voice FR mode (VW) can be select-
ed.
• Name
Enter the desired memory name (up to 16 digits).
• Tone Mode
This item selects the Audio Squelch Code type.
• CTCSS Frequency
This item selects the Tone Frequency of the Tone Squelch.
• DCS Code
Select the DCS code when DCS is set.
• User CTCSS
Select the idle line frequency to remove signals such as idle line signals used by private railways and
control signals of MCA radio system.
24
