CD-15A Rapid Charger
The
CD-15A
is a Rapid Charger that enables recharging of the Lithium-ion Battery Packs
for the Yaesu transceiver
.
Operation
1. Insert the DC plug from the
SAD-11B
,
PA-48B
,
PA-48C
or
PA-48U
into the DC jack on
the
CD-15A
rear panel, then plug the
SAD-11B
,
PA-48B
,
PA-48C
or
PA-48U
into the
AC line outlet.
2. Insert the battery pack into the
CD-15A
. If charging with the transceiver attached,
the antenna jack should be at the left side when viewing the charger from the front. If
charging a pack alone (not attached to the transceiver), refer to the illustration below
for details on proper positioning of the pack; align the slot of the battery pack with the
guide in the nest of the
CD-15A
.
3. If the battery pack is inserted correctly, the Red “
CHARGING
” indicator will glow.
A fully-discharged
FNB-80LI
battery pack will be charged completely in approximate-
ly 2.5 hours.
4. When charging is completed, the Red “
CHARGING
” indicator will disappear, and the
Green “
FULL
” indicator will glow. Disconnect the pack from the
CD-15A
, and unplug
the
SAD-11B
,
PA-48B
,
PA-48C
or
PA-48U
from the AC line outlet.
Important Notes!
Do not connect an improper charger. Use only the
SAD-11B
,
PA-48B
,
PA-48C
or
PA-
48U
with the
CD-15A
.
Do not charge an improper battery (one not specifically designed for use in the
CD-
15A
).
Disconnect the pack from the
CD-15A
, and unplug the
SAD-11B
,
PA-48B
,
PA-48C
or
PA-48U
from the AC line outlet, when charging is completed.
The
SAD-11B
,
PA-48B
,
PA-48C
or
PA-48U
and/or
CD-15A
will generate a moderate
amount of heat during the charging process. This is a normal condition.
The
SAD-11B
,
PA-48B
,
PA-48C
or
PA-48U
is not designed to power the transceiver
for transmission.
Caution!!
When charging a battery pack alone (not attached to the transceiver), do not allow
any metal object to short the terminals on top of the pack.
Do not allow any metal objects to short the terminals in the nest of the
CD-15A
, as a
short-circuit could cause overheating of the charger circuitry.
Specifications
Input Voltage Range
: DC 12.0 ~ 16.0 V
Charging Current
(approx.): 600 mA
Charge Time
(approx.): 2.5 hours (
FNB-80LI
)
Operating Temperature Range
: +5 °C to +35 °C
Case Size
(WxHxD): 90 x 61x81 mm
Weight
(approx.): 145 g
SAD-11B: USA Version
PA-48B: USA/EXP (Non European) Version
PA-48C: EU Version
PA-48U: UK Version
PA-48B, PA-48C and PA-48U are produced in LEI.
Symbols placed on the equipment
Direct current
Align the slot of the bat-
tery pack with the guide in
the nest of the CD-15A.
Check with the latest or your dealer for a list of the
transceivers that can be used with the CD-15A.
YAESU MUSEN CO., LTD.
