1. POWER receptacle
2. SP receptacle
3 . ACC socket
4.
BURST switch
5.
I
HI /LOW switch
6. ANT receptacle
REAR PANEL
Figure 6
A two-pin connector is used for
connection to 13 . 8 Volts DC
(negative ground) power source,
vehicle battery, or AC power
supply.
Audio output is provided at this
receptacle for an external speaker.
(Output impedance is 8 ohms and
the internal speaker will be dis -
abled when a plug is inserted) .
The ACCESSORY socket is used
for external control of the trans -
ceiver.
_
The BURST switch applies a short
"
t��
sj:_11 to the carrier at the
start of each transmission in the
110N'' position. This is normally
µsed only with "tone access" re
peater actuation.
The HI /LOW switch selects the
desired RF power output, 10 Watts
in HI position or 1 Watt in LOW
position.
UHF type coaxial receptacle for
connection of antenna.
- 10 -
Summary of Contents for FT-227R Memorizer
Page 1: ...INSTRUCTION MANUAL FT 227R MEMORIZER YAESU MUSEN CO LTD TOKYO JAPAN...
Page 39: ......
Page 40: ......
Page 42: ...YA E SU v 712 A...