Removing Memories from a Memory Bank
1. While operating in the Memory Bank mode, recall the memory channel to be re-
moved from a Memory Bank.
2. Press and hold in the [
D/MR
(
MW
)] key for one second, then press the [
A/N
(
LOW
)]
key to remove the memory channel data from the Memory Bank.
You must first enter the Memory Bank mode, by pressing the microphone’s
[
] key, before attempting to remove a channel
from a Bank. If you don’t, “MCHERR” will appear when
you press the [A/N(LOW)] key in step (2) above.
Changing a Memory Bank’s Name
You may change the default Memory Bank Name, which is indicated on the display when
you’ve selected a Memory Bank, to a different name, if desired.
1. Press and hold in the [
MHz
(
SET
)] key for one second,
then rotate the
DIAL
knob to select “
9 BNK NM
”.
2. Press the [
MHz
(
SET
)] key momentarily, then rotate the
DIAL
knob to recall the memory bank on which you
wish to change a label.
3. Press the [
A/N
(
LOW
)] key to enable changing of the
name tag.
4. Rotate the
DIAL
knob to select the first digit of the de-
sired label.
5. Press the [
A/N
(
LOW
)] key to move to the next charac-
ter.
6. If you make a mistake, press the [
REV
(
DW
)] key to back-space the cursor, then
re-enter the correct letter, number, or symbol.
7. Repeat steps 4 through 6 to program the remaining let-
ters, numbers, or symbols of the desired label. A total of
six characters may be used in the creation of a label.
8. When you have programmed a name which is under 6
characters, press and hold in the [
MHz
(
SET
)] key for one second to confirm the label
and exit to normal operation.
36
Memory Operation
FT-2980R Operating Manual
