FT-920 Operating Manual
74
U-09 (
DISPLAY
)
Function: Selection of display Multi-Panel charac-
teristics
Available Values:
CLAr
/
PitTCh
/
oFFSEt
Default:
CLAr
This Menu Item allows you to choose which selec-
tion will be displayed in the small Multi Panel, located
immediately to the right of the VFO-A frequency dis-
play. The choices are:
CLAr
Display of the Clarifier offset (in kHz)
from the VFO-A frequency.
PitTCh
Display of the CW Pitch (in Hz)
oFFSEt
Display of the amount of frequency dif-
ference between VFO-A and VFO-B.
U-10 (
E-DISPL
)
Function: Selection of Enhanced Tuning Scale
choices
Available Values:
CLAr
/
dSP
/
tUnE
/
FInE
Default:
dSP
The Enhanced Tuning Scale, located immediately
above the VFO-A frequency display, may be used to
provide a visual indication of several transceiver op-
erating characteristics:
CLAr
When the Clarifier is active, a small dot
below the horizontal Enhanced Tuning
Scale shows the relative offset of the
Clarifier from the displayed VFO-A fre-
quency. Note that this small dot will be
observed on Receive when the R
X
Clarifier is on, but only on transmit
when the T
X
Clarifier is on.
dSP
When the DSP is On, this scale pro-
vides a relative indication of the band-
width currently set via the High-Cut and
Low-Cut knobs.
tUnE
In this mode, an arrow indicates which
direction you should tune on CW in
order to center an incoming tone on
the “zero beat” point with your own sig-
nal.
FInE
When tuning in steps less than 10 Hz,
this scale will expand rapidly as you
tune quickly, but as you tune slowly you
will be able to measure frequency
steps as fine as 1 Hz, thanks to the 1
Hz calibration dots on the Enhanced
Tuning Scale. This feature will be dis-
abled when tuning steps are 10 Hz or
larger.
U-11 (
GROUP1
)
Function: Select the number of Memory Channels
in Group 1
Available Values:
01
~
99
Default:
99
(All Memory Channels are in Group 1 by
default)
Memory Group 1 may be left at 99 channels, in which
case there will be no partitioning of the Memory Sys-
tem. Otherwise, you may set any number less than
99 for inclusion in Group 1 if you wish to partition the
memories.
U-12 (
GROUP2
)
Function: Select the number of memories in Group 2
Available Values: The last digit in Group 1
plus 1 is
the bottom end of Group 2; 99 maximum
Default:
oFF
If, for example, there are 25 memories in Group 1,
Group 2 starts at Memory #26.
U-13 (
GROUP3
)
Function: Select the number of memories in Group 3
Available Values: The last digit in Group 2
plus 1 is
the bottom end of Group 3; 99 maximum
Default:
oFF
If, for example, Group 2 contains Memory Channels
26 through 40, Group 3 begins with
Memory #41.
U-14 (
GROUP4
)
Function: Select the number of memories in Group 4
Available Values: The last digit in Group 3
plus 1 is
the bottom end of Group 4; 99 maximum
Default:
oFF
You do not have to use all 99 memories. Just set the
upper limit of this Menu Item to some value less than
99.
p
Summary of Contents for FT-920
Page 7: ...FT 920 Operating Manual 5...
Page 9: ...FT 920 Operating Manual 7...
