48
Set the VOX (Voice Operated Transmit) delay time
During transmissions using the VOX (Voice Operated Transmit) function, set the time to
return to receive when speaking is paused:
1. Press and hold the [
DISP
] key, and then touch [
TX/
RX
].
2. Touch [
AUDIO
], and then touch [
4 VOX
].
3. Rotate the
DIAL
knob to select [
DELAY
].
4. Press the [
DISP
] key, and then rotate the
DIAL
knob to select the delay time (the
transmit-receive delay after the cessation of speech).
0.5sec / 1.0sec / 1.5sec / 2.0sec / 2.5sec / 3.0sec
5. Press the
PTT
switch to return to normal operation.
Band Scope
The Spectrum Analyzer presents a view of operating activity on channels above and be-
low the centered main band operating frequency.
1. Touch [
F MW
], and then touch [
SCOPE
].
If [
SCOPE
] is not displayed, touch [
FWD →
] to display
[
SCOPE
] and then touch it.
2. With the current operating frequency in the center, the
signal strengths of 39 channels within the bandwidth
are shown on a graph.
3. Touch [
STOP
].
The band scope scanning stops.
•
To resume band scope scanning, touch [
SEARCH
].
4. To turn the Band Scope OFF, press the [
BACK
] key.
Change frequency
•
When a signal on the scope screen is touched, the frequency in the vicinity becomes
the receive frequency, and is set to the center frequency of the scope.
•
The receive frequency may also be changed by turning the
DIAL
knob.
Change the number of channels displayed
•
The number of channels to be displayed may be set to 19CH, 39CH or 79CH, by
touching the channel display area at the top right of the scope screen.
