Page 34
FT
DX
9000D O
PERATION
M
ANUAL
Clarifier Operation
When the CLAR switch (#
above) is pushed, this knob may be used
to program an offset of up to ± 9.99 kHz from the Main (VFO-A) fre-
quency. This offset is only applied, however, to the receive or transmit fre-
quency if the FAST/RX key (#
) and/or BAND/MHz / TX key
(#
), respectively, have been pushed.
To apply the programmed frequency offset to the Receive frequency, press
the FAST/RX key (#
) momentarily. To return to the Main-VFO-A
frequency, without the offset, press the FAST/RX key once more.
To apply the programmed frequency offset to the Transmit frequency,
press the BAND/MHz / TX key (#
) momentarily. To return the
transmitter to the Main-VFO-A frequency, without the offset, press
the BAND/MHz / TX key once more.
To reset the Clarifier frequency to “0” offset, press the B-MODE/
CLEAR switch (#
).
BAND/MHz Up/Down Control
When the BAND/MHz key (#
) is pressed momentarily, the
Red LED imbedded in the switch will light up, and you may then
use this knob for selecting the desired Amateur band. If you have
engaged the “My Bands” feature via Menu #135, this knob will
select from among just the Amateur bands that you have included in
the “My Bands” list.
If you press and hold in the BAND/MHz key (#
) for 2 sec-
onds, the imbedded LED will glow Orange, and this knob may now
be used for rapid tuning in 1 MHz frequency steps.
Memory Channel/Memory Group Control
Pressing the MCH/GRP key (#
) momentarily will enable the
use of this knob for selection of the desired Memory Channel.
Pressing and holding in the MCH/GRP key for two seconds will
enable the use of this knob for selecting the desired Memory Group.
Functions Associated with Sub (VFO-B) Operation
When the A/B switch (#
) is pressed, the Orange lamp to the right of the CLAR/VFO-B knob will light up, and this knob will now be
exercising control functions associated with the Sub (VFO-B) frequency control register. If the Orange lamp is not illuminated, please press the
A/B switch (#
). Rotation of the knob will now control the Sub (VFO-B) frequency.
Sub (VFO-B) FAST Tuning
When the FAST/RX switch (#
) is pressed, the imbedded LED
will light up, and tuning of the Sub (VFO-B) frequency will in-
crease by a factor of 10. Press the FAST/RX button once more to
return to the normal tuning rate.
Sub (VFO-B) BAND/MHz Up/Down Control
If you press the BAND/MHz / TX switch momentarily, the im-
bedded LED will light up, and this knob may now be used for selec-
tion of the desired Amateur band. Pressing the BABD/MHz / TX
switch once again will cancel Up/Down Band selection, and the
LED will turn off.
If you press and hold in the BAND/MHz / TX switch for 2 sec-
onds, the imbedded LED will light up, and this knob may now be
used for Up/Down tuning of the Sub (VFO-B) frequency in 1 MHz
steps. Press the BAND/MHz / TX switch momentarily to cancel
Up/Down tuning; the imbedded LED will turn off.
Sub (VFO-B) Mode Selection
When the B-MODE/CLEAR switch is pressed, the imbedded LED
will light up, and this knob may now be used for selection of the
operating mode for Sub (VFO-B) band operation. Pressing the B-
MODE/CLEAR key once more will cancel mode selection, and
the imbedded LED will turn off.
Note
Mode selection may also be accomplished by pressing the A/B key
(#
), then pressing the appropriate Mode switch (#
) to the left
of the Main tuning Dial.
F
RONT
P
ANEL
C
ONTROLS
CLAR/VFO-B Knob
Depending on the status of the A/B switch (#
, described later) the CLAR/VFO-B is used for functions associated
with the Main (VFO-A) or Sub (VFO-B) frequency control registers.
Advice
Functions Associated with Main (VFO-A) Control
In the case of Main (VFO-A) control, this knob is used for Clarifier tuning, as well as Up/Down selection of the Amateur band, Memory
Channels, 1 MHz tuning steps, or Memory Groups. For Main (VFO-A) control, be sure that the Orange lamp beside this control is not illumi-
nated. If the Orange lamp is turned on, press the A/B switch (#
) to turn it off.
Summary of Contents for FTDX-9000D
