8
Controls & Connections
M-1 Operating Manual
Equalizer memory keys
When the [
1
] or [
2
] key is pressed, the audio signal output from the M-1 mi-
crophone is tailored to the frequency characteristics stored in the respective
memory.
Condenser microphone memory
Dynamic microphone memory
r
Default settings emphasizing the low audio tones are preset in memory 1, set-
tings emphasizing the high audio tones are factory preset in memory 2.
Memory 1
Memory 2
r
The LED of the selected memory, [
1
] or [
2
], lights blue.
r
The frequency characteristics can be fine-tuned for each individual audio band by
turning the graphic equalizer adjustment knobs.
r
The current frequency characteristics can be copied into memory [
1
] or [
2
] by
pressing and holding the appropriate key for one second.
Recording/Playback key
Up to 20 seconds of audio can be recorded. The recorded content can be
replayed using headphones connected to PHONES jack on the rear panel.
The recording can be transmitted by replaying it during a transmission. In
addition, The M-1 may be configured to automatically transmit the recorded
content when the audio memory is replayed (see “Automatically Transmit
the Recorded Message” below).
Recording
1. Press [ ] or [ ] for one second or more to start recording.
r
During recording, the [ ] or [ ] LED lights up red.
2. To stop recording, press the [ ] or [ ] key again, recording will auto-
matically stop after 20 seconds.
Summary of Contents for M-1
Page 1: ......
