VX-8DR O
PERATING
M
ANUAL
51
M
EMORY
O
FFSET
T
UNING
Once you have recalled a particular memory channel, you may easily tune off that chan-
nel, as though you were in the “VFO” mode.
1.
With the
VX-8DR
in the Memory Recall (“MR”) mode, select the desired memory
channel.
2.
Now press the
key, then press
key. The “
MR
” in-
dicator will be replaced by one which says “
TUN
” (“Memory
Tuning”).
3.
Rotate the
DIAL
, as desired, to tune to a new frequency.
The synthesizer steps selected for VFO operation on the current band will be the steps
used during Memory Tuning.
4.
If you wish to return to the original memory frequency, press
key briefly. The
“
TUN
” indicator will be replaced by “
MR
.”
5.
If you wish to store a new frequency set during Memory Tuning, just press and hold
in the
key for one second, per normal memory storage procedure. The micropro-
cessor will automatically set itself to the next-available clear memory location, and
you then press the
key again, briefly to lock in the new frequency.
If you want to replace the original memory contents with the new frequency
settings, be sure to rotate the
DIAL
to the original memory channel number!
Any required CTCSS/DCS changes, or repeater offset modifications, must be done before
storing the data into the new (or original) memory channel location.
M
EMORY
M
ODE
(
R
EGULAR
M
EMORY
C
HANNEL
O
PERATION
)
Summary of Contents for VX-8DR
