VX-8GE O
PERATING
M
ANUAL
11
I
NSTALLATION
OF
FBA-39 A
LKALINE
B
ATTERY
C
ASE
(
O
PTION
)
The optional
FBA-39
Battery Case allows receive monitoring using three “AA” size Al-
kaline batteries. Alkaline batteries can also be used for low power transmission in an
emergency. The power output level selections will be limited to: 1 W/50 mW (for 144/430
MHz FM).
T
O
I
NSTALL
A
LKALINE
B
ATTERIES
INTO
THE
FBA-39
1.
Lift up the lower right corner of the rubber cover, and then open the cover (Figure 1).
2.
Referring to Figure 2, slide the batteries into the
FBA-39
as shown in the illustration,
with the Negative [
–
] side of the batteries touching the spring connections inside the
FBA-39
.
3.
Close the rubber cover.
4.
Install the
FBA-39
in the transceiver in the same manner as the
FNB-101LI
.
I
NSTALLATION
OF
A
CCESSORIES
The
FBA-39
does not provide connections for charging, since Alkaline cells cannot be
re-charged. Therefore, the
PA-44B/C
may safely be connected to the
EXT DC
jack when
the
FBA-39
is installed.
Notes:
The
FBA-39
is designed for use only with AA-type Alkaline cells.
If you do not use the
VX-8GE
for a long time, remove the Alkaline batteries from the
FBA-39
, as battery leakage could cause damage to the
FBA-39
and/or the trans-
ceiver.
Figure 1
Figure 2
Summary of Contents for VX-8GE
Page 71: ...VX 8GE OPERATING MANUAL 69 NOTE ...
Page 125: ...VX 8GE OPERATING MANUAL 123 NOTE ...
Page 165: ...VX 8GE OPERATING MANUAL 163 NOTE ...