VX-8GR/GE O
PERATING
M
ANUAL
98
T
O
L
OCATE
AN
U
NRESPONSIVE
O
PERATOR
U
SING
THE
EAI
FEATURE
1.
Recall the Memory Channel “
EAI
” (must be the same as the
searched person’s radio), which is found in the next to the
last “regular” memory channel.
2.
Set the CTCSS tone pair to the same CTCSS tone pair stored
in the Receiving Pager Code Memory of the missing person’s radio.
1) Press the
f
key, then press the
2
key. This pro-
vides a “Short-cut” to Set Mode Item
63: PAGE CODE-
TX
.
2) Rotate the
DIAL
knob to select the first tone.
3) Press the
M
key.
4) Rotate the
DIAL
knob to select the second tone.
5) Press the
2
key to save the new setting and exit from
setting mode.
3.
Press and hold in the
PTT
switch for five seconds. If the EAI signal is received by a
VX-8GR/GE
transceiver programmed with matching EAI CTCSS tones, the EAI
feature will activate. The lost operator’s radio will transmit a load (0.5 second) beep
every 2.5 seconds until the EAI timer expires. You may now begin direction-finding
efforts.
4.
The ATT (Front End Attenuator) is often helpful in locating
the missing person’s radio, as peaks in weaker signals are
more easily observed. You may select the ATT level “
ATT 1
(10 dB),” “
ATT 2
(50 dB),” and “
ATT OFF
” by pressing the
B
key to reduce the signal.
5.
Press the
c
key to exit to normal operation.
E
MERGENCY
A
UTOMATIC
ID
(
EAI
)
F
EATURE
E
MERGENCY
F
EATURE
