VX-8R O
PERATING
M
ANUAL
110
T
O
L
OCATE
AN
U
NRESPONSIVE
O
PERATOR
U
SING
THE
EAI
FEATURE
1. Recall the Memory Channel “
EAI
EAI
EAI
EAI
EAI
” (must be the same as the
searched person’s radio), which is found in the next to the
last “regular” memory channel.
2. Set the CTCSS tone pair to the same CTCSS tone pair stored
in the Receiving Pager Code Memory of the missing person’s radio.
1) Press the
key, then press the
key. This pro-
vides a “Short-cut” to Set Mode Item
68: PAGE CODE-
68: PAGE CODE-
68: PAGE CODE-
68: PAGE CODE-
68: PAGE CODE-
TX
TX
TX
TX
TX
.
2) Rotate the
DIAL
knob to select the first tone.
3) Press the
key.
4) Rotate the
DIAL
knob to select the second tone.
5) Press the
key to save the new setting and exit from
setting mode.
3. Press and hold in the
PTT
switch for five seconds. If the EAI signal is received by a
VX-8R
transceiver programmed with matching EAI CTCSS tones the EAI feature
will activate. The lost operator’s radio will beep loudly, and its transmitter will re-
spond repeatedly. You may now begin direction-finding efforts.
4. The ATT (Front End Attenuator) is often useful in locating
the missing person’s radio, as peaks in weaker signals are
more easily observed. You may select the ATT level “
ATT 1
ATT 1
ATT 1
ATT 1
ATT 1
(10 dB),” “
ATT 2
ATT 2
ATT 2
ATT 2
ATT 2
(50 dB),” and “
ATT OFF
ATT OFF
ATT OFF
ATT OFF
ATT OFF
” by pressing the
key to reduce the signal.
5. Press the
key to exit to normal operation.
E
MERGENCY
A
UTOMATIC
ID
(
EAI
)
F
EATURE
E
MERGENCY
F
EATURE
Summary of Contents for VX-8R
Page 61: ...VX 8R OPERATING MANUAL 59 NOTE ...
Page 77: ...VX 8R OPERATING MANUAL 75 NOTE ...
