VX-8R O
PERATING
M
ANUAL
168
1. Make sure that the transceiver is off. Remove the hard or soft case, if used.
2. Remove the battery pack.
3. Locate the connector for the
BU-1
under the Caution Seal in the battery compartment
on the back of the transceiver, just peel off the Caution Seal (
Figure 1
).
Cleanly remove the old Caution Seal and adhesive to preserve the submersible per-
formance.
4. Gently install the supplied Connector Board to the transceiver’s connector, then align
the connector on the
BU-1
with the connector of the Connector Board and gently
press the
BU-1
into place (
Figure 2
).
5. Affix the new (supplied) Caution Seal, and replace the battery pack.
6. Installation is now complete.
I
NSTALLATION
OF
THE
BU-1
(
O
PTION
)
Figure 2
Connector Board
BU-1
Figure 1
Summary of Contents for VX-8R
Page 61: ...VX 8R OPERATING MANUAL 59 NOTE ...
Page 77: ...VX 8R OPERATING MANUAL 75 NOTE ...
