24
2. Setting the transmit and receive DG-ID number.
This procedure is unnecessary if the transceiver is already set to the required transmit and receive DG-ID
number.
Since the transmit and receive DG-ID number is “TX: 00” and “RX: 00”, it operates as an open node and is
accessible from all transceivers using C4FM digital mode.
When using a portable node station to be accessed only by the specific members, set the transmit and receive
DG-ID to a number other than “00”.
• In the Access Point, if the receive DG-ID is set to other “00”, set the
transmit
DG-ID number to the same DG-ID
number. Note that setting to a different number will not work properly.
• When setting the receive DG-ID number to “00” and then setting the transmission DG-ID number to anything other
than “00”, the audio of all received C4FM digital stations will be heard on the speaker, but for the transmission DG-
ID Only the matched communication is relayed to the opposite station on the Internet.
• The DG-ID Subcode cannot be used or set in Portable Digital Node mode.
FT5D
1. Press the [
F
menu
] key, and touch [
DG-ID
].
• If [
DG-ID
] is not displayed, touch [
BACK
] to display [
DG-ID
] and then touch it.
• T
he DG-ID SETUP screen is displayed on the LCD.
DG-ID TX : 00
DG-ID RX : 00
2. Press the [
F
menu
] key, then rotate the DIAL knob to set the transmit DG-ID
(DG-ID TX).
When setting the DG-ID number, pressing and holding the [
GM/X
] key will set
the transmit and the receive DG-ID numbers to “00”.
DG-ID TX : 50
DG-ID RX : 00
3. Press the [
F
menu
] key, then rotate the DIAL knob to select “
DG-ID RX
”.
DG-ID TX : 50
DG-ID RX : 00
4. Press the [
F
menu
] key, then rotate the DIAL knob to set the receive DG-ID (DG-ID
RX).
DG-ID TX : 50
DG-ID RX : 50
5. Press the [
BACK
] key or the PTT switch to save the setting and return to the
normal operation.
The setting of the FT5D transceiver is complete.
