1. No stop function: After starting the treadmill, if no one runs for more than five seconds, the
treadmill will automatically stop
2. Hibernation function: When the treadmill stops running, if there is no operation for more
than 10 minutes, it will enter hibernation state. The electronic watch will automatically close
the display and press any key to wake up
Note
1, we mentioned above should be timely to the running plate lubrication, but not
excessive lubrication, lubricant is not the more the better. Remember: reasonable
lubrication is an important factor to improve the service life of the walking machine.
2, check whether you need to put on the lubricant, as long as you grab the running
belt, touch your hand as far as possible to the center of the back of the running belt, if
your hands are stained with silicone oil (a little wet feeling), that is, you do not need to
put on the lubricant, if the running board is dry and hands did not stick to the silicone
oil, you need to add lubricating silicone oil.
3, the running board coated with lubricating silicone oil steps:
a. Set the walking machine to a low speed running 0.6mph;
b. Open the cover on the right side of the front end of the ru nning platform under the
refueling mark; Insert the spout into the nozzle of the filling tube and gently squeeze
the oil can to spray the silicone oil onto the running belt. Run the treadmill at 0.6 MPH
/h to evenly apply the silicone oil. Gently step on the running belt from left to right for
8 to 10 minutes until the silicone oil is completely absorbed into the running belt.
All walking machines should be adjusted before leaving the factory and after installa-
tion, but there may be slack phenomenon after a period of use. For example: when the
user runs, there is a pause and skid. When this phenomenon occurs, in the clockwise
direction of half a circle as a unit, the left and right synchronous adjustment belt
adjustment bolt. (If you want to loose running belt, on the contrary, in the counter-
clockwise direction of operation) run belt loose, foot in the running belt, running belt
and drum will produce skid phenomenon, but too tight is not good, easy to increase
the load of the motor, damage the motor, running belt and drum.
The running belt is centered
Plate lubrication
Running belt elastic adjustment
6
Summary of Contents for ZF-0301
Page 1: ......
