5
6
Install the spine bolt, washers, and nut.
You may need to wiggle the spine to
get the bolt to pass through. Then fully
tighten using the provided wrenches.
Remove the attachment
hardware from the tray
assemblies.
A
B
C
D
B
8X
34 Nm (25 ft-lbs)
7
A. Place the the lower tray assembly into position. It's the
assembly with the large Yakima sticker. Orient the tray
so that the sticker is right side up.
B. Install the hardware and fully tighten to 17 ft-lbs (23Nm).
C. Place the upper tray assembly into position.
D. Install the hardware and fully tighten to 17 ft-lbs (23Nm).
