A
B
1033501E-3/21
Adjust both straps by pulling on free ends
of straps toward top hooks, or by pressing
the release buttons on the buckles.
Note: Leave straps slightly loose. Straps
will be fully tightened in a later step.
Attach top hooks.
Attach both top strap hooks (labeled TOP) around top edge
of the Trunk Lid, hatch lid, or rear door. They should be
parallel, and no wider then the body of the QuickBack.
Straps should be routed
over
the frame.
WARNING: DO NOT ATTACH THE UPPER HOOKS TO GLASS, PLASTIC, OR
SPOILERS! USE THE GLASS HATCH ADAPTERS. USE OF THE GLASS HATCH
ADAPTERS WILL LIMIT THE LOAD TO TWO BIKES ONLY.
Follow Glass Hatch Adapter installation instructions below.
RePlAcING UPPeR STRAP HOOkS
WITH GlASS HATcH AdAPTeRS
OPEN THE
HATCH
DOOR.
PULL EXISTING
UPPER STRAPS
COMPLETELY
OUT OF THE
BUCKLES.
Keep the pads away
from the door’s edge.
Pass the Glass Hatch Adapter
strap ends through the hatch
opening from inside the
vehicle.
No glass or plastic? You won’t need the
Glass Hatch Adapters, continue to STEP 5.
WARNING: Do not pull
upper straps sideways!
