Resetting Lock to Factory Default
1. Remove inside lever with the
supplied lever removal tool.
2. Remove the battery cover with
supplied hex wrench and then
remove batteries.
3. Remove network module if installed.
4. Remove the 10-32 x 3/4" pan
head screw from the center of
the battery housing.
5. Remove the inside lock
from the door to access the
reset button on back of
inside lock. Cables may stay
connected. (See illustration
above for location of the reset
button.)
6. Reinstall four (4) AA batteries.
7. Press the reset button for 3
seconds.
8. While continuing to press the
reset button, temporarily
remove one (1) AA battery.
9. Reinstall the battery.
10. Release reset button and wait
approximately 15 seconds.
Speaker will announce
"Welcome to Yale."
11. Reassemble inside lock and
lever.
12. If utilizing a network module,
remove batteries. Insert module.
Reinstall batteries.
Inside Lock
When lock is reset to factory defaults all PIN codes (including the Master PIN code*) are deleted
and all programming features are reset to original default settings (see Factory Settings).
Upon reset, Master PIN Code creation is the only option available and must be performed prior to
any other programming of the lock.
Lever Removal Tool
Hex Wrench
Button
Reset
IMPORTANT: The Reset Button is located on Inside Lock.
The keypad remains assembled.
19
80-9150-0080-010 11-21
Part of ASSA ABLOY
