YDV4202-V1
How to set the unlock parameter
Unlock time:
How to set the monitor as a Guard Monitor
A Monitor can be assigned as Guard Unit Monitor. A call can be placed directly to
the Guard Unit Monitor, bypassing the Intercom Menu.
The code 8004 is used to set the monitor as a guard unit monitor and 8005 to cancell
this function.
How to set the secundary/slave monitors to view image when call is made
In default mode and when receiveing a call, the master and slave monitors will ring at the
same time, but just the master monitor will display the image, while the slave monitors
will not. This setting can be changed to have all the monitors (master and slave), dispaly
the image at the same time while receiving a call by using the code 8006 on each slave
monitor.
1. Power-on- to-unlock type: Unlock mode = 0 (default setting)
2.power-off-to-unlock: Unlock mode = 1
The code number of 8010 is used to set the unlock mode to 0
The code number of 8011 is used to set the unlock mode to 1
Two types of unlock modes:
The unlock time can also be changed. It can be set from 1 to 9 seconds.
The code number from 8021 to 8029 are used to set the unlock time, being the last digits
the number of seconds (1~ 9 seconds).
