11
Command Class Battery, Version 1*
* This command class requires security.
Per the Z-Wave Plus
™
Specification, the lock will send a Battery Report with a
value of 0xFF to the Lifeline node when a critical battery level is reached (starting
at about 4.2V for Product Type ID 0x8104). In addition, the Yale Locks provide 2
earlier low battery alarms through the notification command class (see Table 7 -
Notification Table).
Low battery alarms will be generated if the lock is in a low battery state during one
of the following events: any motor activation (keypad lock/unlock, RF lock/unlock,
etc.), controller sends Get Battery command, or the unsolicited battery report was
triggered. Yale locks will generate an unsolicited Battery Report at lock boot-up and
every 8 hours if a node is listed in the Lifeline Group.
Command Class Door Lock, Version 4*
* This command class requires security.
Yale Z-Wave Plus
™
locks support three door lock modes: Door Secured (0xFF),
Door Unsecured (0x00), and Door Unsecured with timeout (0x01). When Auto
Relock is enabled, the lock will automatically relock after all unlock events. Yale Z-
Wave Plus
™
locks do not support any of the
“Door Unsecured for outside
Door
Handles
”
(0x20, 0x21) or
“Door Unsecured for inside
Door Handles
” (0x10, 0x11)
modes.
Command Class Door Lock Logging, Version 1*
* This command class requires security.
This command class has been implemented per the Z-Wave
™
Specification.
Command Class Schedule Entry Lock, Version 3*
* This command class requires security.
Yale locks support Year Day Schedule types and Daily Repeating Schedule types.
Yale locks allow the controller to apply multiple schedules to a single user. Each
user has 1 Year Day Schedule slot (Slot ID 1) and 7 Daily Repeating slots (Slot IDs
1
–
7). If user scheduling is used in the lock, then the controller
MUST
set the
lock
’
s time using the Time Parameters command class.
