31
P/N YRL-EMICL-256-KFTSINSTL-FUL Rev A
Resetting Lock to Factory Default
Reset Button
Access
Interior Lock
(4" Shown)
Factory Settings
When resetting the lock, all user codes,
including the Master PIN code*, are deleted. All
programming features are reset to original
default settings (see below).
1. Remove the battery cover and batteries.
2. Remove the interior lock to access the reset
button hole. (See image at right.)
3. Re-insert 3 batteries and insert a small
screwdriver into the hole; holding the reset
button for 3 seconds.
4. While still holding the reset button, insert the
4th battery and hold the reset button for an
additional 3 seconds.
5. Release the reset button.
6. Re-install the interior lock onto the door.
Upon reset, Master PIN Code creation is the
only option available and must be performed
prior to any other programming of the lock.
*The Master PIN code must be registered prior to any other
programming of the lock.
Factory Setting
Registration
required*
Disabled
Disabled (Off)
Enabled
Enabled (Low)
5 Times
60 Seconds
Settings
Master PIN Code
Automatic Re-lock
Inside Indicator Light
One Touch Locking
Volume Setting
Wrong Code Entry Limit
Shutdown Time
For best results, the lock should be installed on the
door when resetting the lock to factory default. If the
process was done and the lock was not installed on
the door, review the Re-Handing instructions listed in
Hardware Troubleshooting.
Please use this procedure only when network
primary controller is missing or otherwise inoperable.
Disabled
Privacy Button Setting
Disabled
Lockout Mode
English
Language Setting