18
After an OTA is performed (a Firmware Update Status Report should return with
successful), there is an additional step internally where we write/apply the image to
the lock/module. When the image is being applied to the lock, the lock is
unresponsive until completion of the apply image. Once the completion of the OTA
image is applied the lock silently reboots.
The following is the time it takes for each product to complete OTA image apply
phase:
•
For Z-Wave
™
Radio Chip, ~10 seconds
•
For YRC/D216-ZW3 (Push Button interface), ~ 3 minutes
•
For YRC/D226-ZW3 and YRC/D256-ZW3 (Touch Screen interface), ~ 3
minutes
•
For YRC/D652-ZW3 & NF-YRC/D622-ZW3 (2nd Generation Touch Screen
interface), ~ 13 minutes
•
For NF-YRC/D612-ZW3 (2nd Generation Push Button interface), ~ 13
minutes
•
For YRC/D622-ZW3 & YRC/D642-ZW3 (2nd Generation Fire Rated Touch
Screen Deadbolt), ~23 minutes
•
For YRD410-ZW3, YRD420-ZW3, YRD430-ZW3 & YRD450-ZW3 (2nd
Generation Assure Deadbolt), ~23 minutes (full image) ~3 minutes
(patch/differential image)
Command Class Association, Version 2*
* This command class requires security.
This command class has been implemented per the Z-Wave
™
Specification.
Command Class Multi Channel Association, Version 3*
* This command class requires security.
This command class has been implemented per the Z-Wave
™
Specification.
Yale locks support only one group, which can contain up to 5 nodes.
