An ASSA ABLOY Group brand
80-9150-8005-010 (10-12)
7
Battery Replacement
Troubleshooting
P r o
b
l em
Green light comes on but lever will not retract latchbolt.
Solution
Check lockbody connection. Check cylinder tail piece length (see Installation Instructions).
Problem
No Lights come on when pushbuttons are depressed.
Solution
Problem
No Audible when pushbuttons are depressed.
Solution
Problem
Factory default codes not working
Solution
Reprogram default codes (Delete All Users) (See page 5) .
Problem
User codes not working
Solution
Problem
Lock stays unlocked
Solution
The lock goes into Blackout Mode when the voltage drops to 5.4V. If this happens users 6-99
will be locked out. Supervisor and Emergency codes are the only codes that will allow access.
The codes will not be lost during battery replacement or low power conditions. Codes are stored
in non-volatile memory. To replace the batteries remove the screw on the Battery Escutcheon
and remove the escutcheon. Replace all 6 “AA” (alkaline only) batteries in the correct polarity
position. Reinstall the escutcheon. Enter a known user code to ensure lock functions correctly.
Ensure Visual Keypad Feedback is set to Enable (See page 6). Check battery installation.
Check keypad connection.
Ensure Audible Keypad Feedback is set to Enable (See page 6). Check battery installation.
Check keypad connection.
Ensure Lockout code has not been entered (See page 3). Check battery power (lock maybe in
Blackout Mode). See below for battery replacement. Check lockbody connection.
Ensure Passage code has not been entered (See page 3). Check cylinder tail piece length
(see Installation Instructions). Check lockbody connection.
Check door Prep (refer to door templates).
