12
Key Fob Battery Change
When the battery is low the LED will glow dimly when
any key is pressed. The battery is changed as
follows:
1.
Using a coin turn the battery cover anticlockwise
to the unlocked position and remove cover and
battery.
2.
Insert new CR2032 coin cell battery with the
+ side uppermost (see diagram below).
3.
Replace battery cover. Press any key and check
that the LED lights. If the LED lights the new
battery installation is successful.
Key Pad Battery Change
When the battery is low the LED will flash when any
key is pressed. The battery is changed as follows:
1.
Switch off tamper protection as described on
page 9, Table 1.
2.
Unscrew the two Key Pad case screws and
remove Key Pad back to reveal battery.
3.
Using a screwdriver gently lever out the old
battery.
4.
Insert new CR2032 coin cell battery with the
+ side uppermost. (See picture below).
5.
Press battery into holder firmly with finger and
thumb until a click is heard (see picture below).
6.
Press a number key and check that the LED lights.
If the LED lights the new battery installation is successful,
screw the Key Pad case back on and the battery change is
complete.
Panic Button Battery Change
When the battery is low the LED will glow dimly when
the button is pressed. The battery is changed as
follows:
1.
Loosen the bottom case screw and take button
cover off base.
2.
Insert the new CR2032 coin cell battery with the
+ side uppermost (see picture below)
3.
Replace button cover. Press the button and check
that the LED lights. If the LED lights the new
battery installation is successful.
Smoke Detector Battery Change
When the battery is low the LED will flash
accompanied by a low volume beep once every
30 seconds.
1.
Rotate Smoke Detector anti-clockwise to detach
from base bayonet fixing.
2.
Insert 3 x AA alkaline batteries, taking care to
observe polarity and wait 10 minutes for the
Smoke Detector to recalibrate itself, indicted by
a rapidly flashing LED.
3.
Replace Smoke Detector on base and rotate
clockwise to lock.
4.
Press the test button and check that the LED
lights and the sounder chimes to confirm the new
battery installation is successful.
IMPORTANT
Insert the battery under the two
tabs and click into place.
Insert flat head screwdriver to
remove battery
Battery Removal and Insertion. Door/Window Contact Key Pad and Panic
Button
Changing the batteries
(Continued)
8