14
Siren reset procedure
• Switch the power switch to ‘Off’ position. Press
the learn button a few times to drain any residual
power.
• Switch dip switch 1 to ‘On’ position
• Switch the power switch to ‘On’ position.
Wait 5 seconds. Siren LED will flash 1 cycle.
• Switch dip switch 1 to ‘Off’ position
The Siren is now reset and all learnt devices are
cleared from memory. See chapter 3 for initial
set-up. Please be reminded that all devices will need
to be learnt in at this point. Individually, press the
learn button on device to learnt in.
Key Pad reset procedure
The Key Pad is tamper protected. Please ensure
the siren tamper is disabled before you open the
Key Pad cover. See Page 9, table 1 for siren tamper
disable procedure.
• Open cover and remove battery. Reinsert with
the number “3” key pressed (taking care 3 is held
down).
• The Key Pad will go back to the “0000” Key Pad
code.
• The Key Pad will now have to be re-learnt into the
Siren, see chapter 3.
9
Troubleshooting
(Continued)
8
Consumer Support Helpline
Should you have any questions or experience
a problem with your Yale Alarm Kit, please
contact our Consumer Support Helpline.
Tel:
01902 364606
Monday - Friday 8.30am - 5.30pm
Email:
info@yale.co.uk
