5
Programming the system
3
The Siren is the heart of the system. All components must be recognised by the Siren.
Enable/disable Jamming & interference
detection:
• Set Dip switch 2 On to enable interference
detection or Off to disable interference detection
(recommended default).
The system is now ready for mounting
.
2.
3.
Switch the Siren’s power switch to ON
(The LEDs will now flash with one short beep.)
Once powered, the Siren will enter learn
mode for
3 hours
. All tamper protections
are disabled during this time period. Please
ensure that ALL devices are fitted whilst the
Siren is still in learn mode.
1.
The system is pre-learnt in the factory and the
system should recognised all the items (within
this kit) as default.
If the items are not recognised, deleted by
accident or purchased accessories, please
press the learn button on the accessories (when
the power switch is first turned on and in learn
mode) to learn each one into the system.
Do not
press the Siren learn button. See Chapter 2 for
learn button location. The Siren will beep each
time it receives a learn signal to indicate that the
accessory is now recognised by the system.
i
This system is equipped with the latest type
of radio receiver using FM radio technology.
If the system is armed any criminal attempt
to interfere with the system transmissions
will trigger an alarm. If the alarm is frequently
triggered by interference there may be high
levels of unusual radio signals in your area.
Some kinds of electronic equipment can
generate this kind of radio interference. In the
unlikely event of you experiencing problems
with interference, it is recommended that you
switch interference detection off.
i
WARNING
The Siren is very loud, be prepared!
Take care not to activate the Siren tamper
switch unnecessarily.
