6
Mounting devices
4
Before mounting the Key Pad and Siren ensure that the Siren tamper is
disabled. (See page 9 tables 1 and 2).
Mounting the Siren
Ensure the tamper switch is fully depressed when
the Siren is mounted. If there is a gap, pack with a
suitable spacing material.
Round
Siren
Base
Wall
Spring Guide
Spring compressed
firmly against wall
1.
Using the large screws and wall plugs provided,
screw the Siren onto the wall through the 4
mounting holes on the Siren base.
2.
Fix the Siren cover with the securing screw.
Mounting other devices
Find a location where the device is to be mounted,
see section “Location Planning” (Page 2) for
suggestions.
Mounting the Key Pad:
1.
Knock out the fixing holes. Drill holes into the wall
using the fixing holes as a template.
2.
Fit wall plugs into the wall and fix back cover with
the screws provided. Fix front of the Key Pad onto
the back plate.
Battery Saver tab
Wall Fixing
knockouts x2
Mounting the PIR Motion Detector
1.
Open the PIR by loosening the bottom screw.
Knock out the relevant holes on the base where
the plastic is thinner. The center two knockout
holes are for flat wall mounting while the 4 side
holes are for corner mounting.
Wall fixing
knockouts x2
Corner fixing
knockouts x4
Battery tab
2.
Drill holes into the wall using the knockout holes
on the base as a template.
3
. Fit wall plugs and secure the PIR base with the
screws provided.
4.
Fit the PIR back together and tighten the bottom
screw. The PIR installation is complete.
Before proceeding to mount the devices,
physically check that the Siren will receive the
system radio transmissions by doing a simple
radio range test.
•
Key Pad:
Hold the Key Pad in the desired
location and press the arm button.
(The Siren will beep as confirmation.)
•
Panic Button:
Hold the device in the
desired location and press the learn/test
button for 2 seconds.
(The Siren should respond with a single beep.)
•
All other devices:
Hold the device in the
desired location and press the learn/test
button.
(The Siren should respond with a single beep.)
When you are satisfied that the devices work
in your chosen locations, proceed with the
installation as described in the next page.
If the Siren does not respond, the location may
be out of range. Try alternative locations to
establish a reliable radio signal.
i