Figure 63. Setup Screen for Impact Settings
The top left icon is the Impact Detection Icon. To set impact detection to On or Off, use the
2
and
3
soft keys
to select the current value for this setting. When there is a box around the On or Off Icon, use the
2
or
3
soft
key to display the desired setting and press the
Enter Key
to save it.
The second icon down from the top is the Impact Monitor Shutdown Delay Icon. To set the Shutdown Delay,
use the
2
and
3
soft keys to select the current value for this setting. When there is a box around the value,
press the
Enter Key
, then use the number keys on the Display Panel to enter a value from 0 to 30 seconds and
press the
Enter Key
to save the new setting.
The third icon down from the top is the Impact Monitor Shutdown Type Icon. To set the Disable Type to All
or Traction, use the
2
and
3
soft keys to select the current value for this setting. When there is a box around
the All Icon or the Traction Icon, use the
2
or
3
soft key to display the desired setting and press the
Enter Key
to save it.
MOTOR BRAKING
NOTE:
This submenu is available to logged in Service Technicians and Supervisors.
There are three motor braking settings, Regenerative Braking Rate, Auto Deceleration Rate, and Auto
Deceleration Type. See
.
Regenerative Braking setting controls how much motor braking is applied when the direction is changed from
Forward to Reverse or Reverse to Forward. This type of deceleration is proportional to the accelerator pedal
position. The further the accelerator is depressed the greater the deceleration.
Auto Deceleration setting controls how much motor braking is applied when transitioning from higher
accelerator pedal position to a lower acceleration pedal position. There are two types of Auto Deceleration,
Pedal Up and Proportional. A fully released pedal produces maximum deceleration for both Pedal Up or
Proportional deceleration.
Figure 64. Motor Braking Setup
Changing the Motor Braking Settings
To change the Set Regenerative Braking Rate or Set Auto Deceleration Rate setting, use the
2
and
3
soft keys
to select the current value of the setting you want to adjust. When there is a box around the value you want to
change, press the
Enter Key
. Next, use the number keys to enter the desired value, then press the
Enter Key
to save the new setting.
The Regenerative Braking Rate setting is the value at the top of the screen. This value can be from 0 to 100%
Summary of Contents for ERC030VA
