screen, as
shows.
The process for viewing and removing the system's operator checklist logs is shown in
Table 18.
Access Impact Events Log Screens
!!
—
Scroll Keys
—
▸
Activity Log
Main menu
↑
Up
Arrow/Down
Arrow Soft
Key
↓
Activity Log
Impact
Events Log
Submenu
Press Enter Key (*)
The most recent
Impact Events Log
entry will display
Press the Up Arrow or Down
Arrow soft key to scroll through
the log entries
To remove all log entries:
Press Trash Can (
#
) Key to remove
all entries
This log screen is
replaced by the
Empty log screen
Press either Scroll
Key (
!!
—
or
—
▸
)
to exit
When a person with Supervisor password-level access views the log, any recorded events under Service
Technician-level access are shown as
*****
instead of the actual password number. Also, if there was no
password logged in at the time of an event, the password appears as
*****
.
Calibration Menu
INTRODUCTION
The Calibration Menu is a main menu (top-level menu) that is visible at Service Technician, Supervisor, and
Operator password access levels. The
topic shows the icons displayed on calibration screens. To
access this menu, cycle through the main menu title screens by pressing the
Scroll Back Key
(
?—
) or
Scroll
Forward Key
(
—?
) until the Calibration Title Screen is displayed, as shown in
.
Summary of Contents for ERC030VA
