Figure 36. Manual Hydraulic End Point Calibration
1
With no load on the forks, raise them, if they are not already raised.
2
Starting from the Calibration Menu, scroll to the Manual Hydraulic End Point Calibration screen and
press the
Enter Key
.
3
When prompted, move all hydraulic levers to both of their extreme locations; that is, move each lever
as far as it will go in both directions.
4
Press the
Enter Key
. The system records the extreme locations and returns to the Calibration Menu.
Display Menu
INTRODUCTION
The Display Menu is a main menu (top-level menu) that is visible at Supervisor and Service Technician
password access levels. To access this menu, cycle through the main level menu screens by pressing the
Scroll Back Key
(
!!
—
) or
Scroll Forward Key
(
—
▸
) until the Display Title Screen is displayed, as shown in
.
Figure 37. Display Title Screen
Summary of Contents for ERC030VA
