6
Adjust for Door Thickness (If Necessary)
1. Remove cylinder handle:
A. Insert key and rotate 45 degrees counterclockwise.
B. Insert lever retainer tool and push.
C. Slide lever off lock.
2. Remove the plastic sleeve from the old cylinder.
3. Slide new cylinder into sleeve.
4. Insert key into cylinder.
Important: Make sure the key cut side of key lines
up facing towards the end of the lever. If the key is
inserted incorrectly, the lock will reassemble and
might appear to properly work; however, when the
key is removed, the latchbolt will remain retracted.
5. Rotate key 45 degrees counterclockwise.
Depress retainer plate, push the handle onto the shank until fully seated.
Pull on handle to insure properly seated.
How to Replace, Re-Key or Install Cylinder
A
C
B
Key cut
Lock is provided standard for use on 1-3/4" thick doors. For use on 1-3/8" thick doors, special
thin door kit must be used. To order 1-3/8" thin door kit, specify part number 14-4761-0106.
This kit includes inside and outside escutcheon spacers as well as a 2-3/8" latchbolt. Note:
using a 2-3/8" latchbolt results in Grade 2 certification on the lock.
®
CAUTION: For units shipped prior to March 2012: The cylinders furnished with inTouch lock for
use in 1-3/8" doors have a tailpiece that is 1/4" shorter than the standard cylinders that are
furnished for 1-3/4" doors. Trying to install a standard cylinder in locksets designed for 1-3/8"
doors will DAMAGE the lock body.
Outside Keypad Escutcheon Gasket
Inside Escutcheon Gasket
An ASSA ABLOY Group brand
80-9150-0075-010 (08-12)
