Turtle Alarm enable
This parameter sets an alarm to indicate when the
truck has transition from turtle mode (TM1) to turtle
mode 2 (TM2). The truck will transition from TM1 to
TM2 when the truck is been driven in TM1 and turtle
button is depressed while tiller arm transition from
operational region A to operational region B. See
Figure 9030-03-3.
A. OPERATIONAL REGION A
B. OPERATIONAL REGION B
C. OPERATIONAL REGION C
Figure 9030-03-3. Operational Regions
Quick Lift Window
This optional parameter defines the minimum amount
of time that the lift button needs to be depressed to
activate Quick Lift.
Initial Lift Interval
This optional parameter sets the period of time for
which the truck will lift upon Quick Lift command. It
shall be enough to lift up the load from the ground so
that load wheels can move freely.
Full Lift Interval
This optional parameter sets the period of time for
which the truck will lift once traction is commanded
while Quick Lift mode.
Lift Run Time
This parameter sets the maximum allowable time to
have the motor pump running upon lift command.
BDI Warning (Lift Lock) Enable
This parameter enables the truck to lock the lift
function when BDI reaches a given percent
Warning BDI (Lift Lock Out Percent)
This parameter will set the battery discharge
percentage at which the truck will lock the lift function
Battery-BDI Reset Volts
The reset voltage level is checked only once, when
KSI is first turned on. Note that the BDI Reset Percent
parameter also influences the algorithm that
determines whether BDI Percentage is reset to 100%.
Reset Volts Per Cell should always be set higher than
Full Volts Per Cell.
Battery- BDI Full Volts
The full voltage level sets the Keyswitch Voltage that is
considered to be state-of-charge; when a loaded
battery drops below this voltage, it begins to lose
charge. The BDI (battery discharge indicator)
algorithm continuously calculates the battery state-of-
charge whenever KSI is on.
Battery-BDI Empty Volts
The empty voltage level sets the Keyswitch_Voltage
that is considered to 0% state-of-charge when the
truck is been used (loaded conditions). The BDI
(battery discharge indicator) algorithm continuously
calculates the battery state-of-charge whenever KSI is
on.
Battery-BDI Discharge Time
This parameter has two functions:
•
Sets the minimum time for the BDI to count
down from 100% to 0%. If upon verification
battery voltage is below corresponding BDI
percent, BDI percent will decrement by one
percentage point.
•
Sets the frequency at which the BDI will check
the battery voltage. If upon verification battery
voltage is below corresponding BDI percent,
BDI percent will decrement by one percentage
point.
General Maintenance and Diagnostic Data
ELECTRICAL SYSTEM
Check the Service Manual section in Yale Axcess Online for possible updates and check pertinent Bulletins
9030-03-10
Confidential/Proprietary - Do Not Copy or Duplicate
Summary of Contents for MPB045VG
