6
Ducting Options
Closely follow the instructions set out in this manual. All
responsability, for any eventual inconveniences, damages or fires
caused by not complying with the instructions in this manual, is
declined.
Preparation
Do not cut a joist or stud unless absolutely necessary. If a joist or
stud must be cut, then a supporting frame must be
constructed.
Fittings material is provided to secure the hood to most types of
walls/ceilings.
However, a qualified technician must verify suitability of the
materials in accordance with the type of wall/ceiling.
Before making cutouts, make sure there is proper clearance
within the ceiling or wall for exhaust vent.
The hood is equipped with an 10” (25.4 cm) round transition for
discharge of fumes to the outside.
Roof Venting
Wall Venting
A
B
B
C
A
A.10” (25.4 cm) round vent
B. Wall cap
A. Wall cap
B. 10” (25.4 cm) round vent
C. 90º elbow
CAUTION
For gas cooktop & range installations: Mount the hood so the
bottom is at least 30” (76.2 cm) above the cooking surface.
For electric/induction cooktop & range installations: Mount the
hood so the bottom is at least 24” (61 cm) above the cooking
surface.
There is no maximum mounting height, however, we recommend
mounting the hood no greater than 36” (91.4 cm) above the
cooking surface. For every inch (2.54 cm) above 36” (91.4 cm),
fume and moisture capture efficiency diminishes at an increasing
rate and may not deliver an acceptable level of ventilating
performance.
This hood is intended for household use.
PLEASE READ THE INSTALLATION MANUAL FOR SPECIFIC
APPLICATION. Check your ceiling height and hood height before
selecting your hood.
Prepare the Location
•
Disconnect power.
•
Determine which venting method to use: roof or wall exhaust.
•
Select a flat surface for assembling the hood insert.Place
covering over that surface.
•
It is recommended that the vent system be installed before
hood is installed.
•
Before making cutouts, make sure there is proper clearance
within the ceiling or wall for exhaust vent.
•
Hood insert should be installed a minimum 24” (61 cm) above
an electric cooktop surface and 30” (76.2 cm) above a gas cook
top surface. The maximum recommended height over both
cook tops is 36” (91.44 cm).
•
Check that all installation parts have been removed from the
shipping carton.
•
Using 2 or more people, lift hood insert onto covered surface.
•
Remove the filters. See the “Cleaning” section.
Dimensions and Clearances
This range hood has the flexibility to be installed in two different ways, depending on the width measurement or working area between
the left and right cabinetry. Before beginning, it is important to determine the dimension of this working area and to consider the
measurements detailed in the next table.
Range Hood
Models
Range Hood
width without
spacers
Range Hood
width with
spacers
Range
Hood
Depth
PINSV628SS
28½”
(72.3 cm)
30 ”
(76.2 cm)
15 ”
(39.8 cm)
PINSV134SS
34½”
(87 cm)
36”
(91.44 cm)
PINTR628SS
28½”
(72.3 5 cm)
30 ”
(76.2 cm)
18"
(45.7 cm)
PINTR634SS
34½”
(87 cm)
36”
(91.44 cm)
PINTR146SS
46½”
(117.8 cm)
48”
(121.9 cm)
Summary of Contents for PINTR634SS
Page 32: ...32...
