5
An ASSA ABLOY Group brand
P/N AYRT-220-INST-FUL Rev B
INSTALL LOCK
Preparation
A. Remove the latch (Fig. A) and strike from the packaging.
If required, pull to extend to 2-3/4" backset position.
NOTE
: Different holes are used for (2) through bolt posts depending on backset (Fig. A).
Figure A
2-3/8" through bolt posts
2-3/4" through bolt posts
Before installing the lock on the door:
NOTE
: The latch can be installed in only one of two ways - with the
bevel
(slope) of the
latch facing out or facing in
while standing outside of the door.
NOTE
:
Both latch face and strike have adhesive-backed covers to prevent marring and
should be removed upon installation.
IMPORTANT: Latch bevel must match door bevel
and plunger of deadlocking latch must stop on
strike when door is closed.
Make sure door has been prepped according to specifications in template
included with lock.
If the door opens
in
, the bevel will face the exterior (regular); if
the doors opens
out
, the bevel will face the interior (reverse).
Strike
Plunger
NOTE
: Latch ships with backset in 2-3/8" position (Fig. A).
Backset
is the measurement from door edge to center of 2-1/8" diameter hole
(see template supplied with lock).
