7
An ASSA ABLOY Group brand
P/N AYRT-220-INST-FUL Rev B
Figure 4
3. From outside of door, position the exterior escutcheon by first routing the wire
harness through 2-1/8" diameter hole and
under
the latch (Fig. 4 & 5), then
inserting the through posts
*
and tailpiece/square drive tube into the latch (Fig. 5).
NOTE: Wire harness goes
under latch (Fig. 4 & 5).
Exterior of Door
Figure 5
Interior of Door
"Top" of Drive Tube
(marked BLACK)
Tailpiece
horizontal
*
Posts are inserted in holes according to
backset adjustment. (Refer to Fig. A under
"Lock Preparation")
4. Remove the interior mounting plate (with gasket) from the back (door side) of the interior
escutcheon (Fig. 6).
A. Ensure that gasket on
interior mounting plate
is properly fitted (Fig. 7).
Figure 7
Figure 6
Interior Escutcheon & Mounting Plate
(with gasket)
5. Remove the battery cover from the back of the interior escutcheon (Fig. 8) by
loosening the captive Phillips head screw, then lifting the cover up and out.
Note tabs at bottom of cover.
Phillips Head
Screw
Battery Cover
Figure 8
