29
Command Class Basic, Version 2*
* This command class requires security.
This command class is mapped to Door Lock CC:
Table 11
–
Basic Mapping Overview
Basic Command
Door Lock Mapped Command
Basic Set (Value)
Door Lock Operation Set (Door Lock
Mode)
Basic Report (Current Value = 0x00)
Door Lock Operation Report (Door Lock
Mode = 0x00)
Basic Report (Current Value = 0xFF)
Door Lock Operation Report (Door Lock
Mode > 0x00)
The Basic Get Current Value, Basic Get Duration, and Basic Get Target Value are
mapped to Door Lock Operation Get and Basic Set is directly mapped to Door Lock
Operation Set where the Duration is returned as is, but the Value and Target Door
Lock State Value of the Basic Report use the following mapping:
Table 12
–
Basic Report: Value
Value
Level
State
Door Lock State
0 (0x00)
0%
Off
Unsecure
1..99
(0x01...0x63)
1..100%
On
Secure
100..253
(0x64...0xFD)
Reserved
Reserved
254 (0xFE)
Unknown
Unknown
Unknown
255 (0xFF)
100%
On
Secure
Summary of Contents for real Living YRC226
Page 8: ...Changing Handing if necessary continued 3 8 P N Rev G YRL EMICL TSINSTL FUL...
Page 16: ...16 P N Rev G YRL EMICL TSINSTL FUL Testing Deadbolt Latchbolt Operation Outside of Door...
Page 17: ...17 P N Rev G YRL EMICL TSINSTL FUL 10 Remove Battery Cover Loosen screw to remove cover...
Page 35: ...35 P N Rev G YRL EMICL TSINSTL FUL Programming Troubleshooting Symptom Suggested Action...
