P/N
-
-
Rev A
AYRD 156-INST FUL
19
!
Warning:
Changes or modifications to this device, not expressly approved by
ASSA
ABLOY Residential Group
could void the user's authority to operate the equipment.
FCC:
Contain FCC ID: 2ABFG- YRIZW2USTS1
Model: YRD156-ZW-619,605,0BP
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the
Rules. These limits are
FCC
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful Interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
THIS DEVICE COMPLIES WITH PART
OF THE FCC
15
RULES OPERATION IS SUBJECT TO THE FOLLOWING
.
TWO CONDITIONS.
(1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE AND
THIS DEVICE MUST ACCEPT
,
(2)
ANY INTERFERENCE RECEIVED INCLUDING
,
INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
Industry Canada:
Contain 11626A- YRIZW2USTS1
Model: YRD156-ZW-619,605,0BP
Section 7.1.2 of
-
RSS GEN
Under Industry Canada
regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser)
gain approved for the transmitter by Industry Canada.
To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for
successful communication.
En vertu des règlements d'Industrie Canada, cet
émetteur radio ne peut fonctionner avec une antenne
d'un type et un maximum (ou moins) approuvés pour
gagner de l'émetteur par Industrie Canada. Pour
réduire le risque d'interférence aux autres
utilisateurs, le type d'antenne et son gain doivent
être choisies de façon que la puissance isotrope
rayonnée équivalente (
) ne dépasse pas ce qui
PIRE
est nécessaire pour une communication réussie.
Section 7.1.3 of
-
RSS GEN
This Device complies with
Industry Canada License-exempt
standard(s).
RSS
Operation is subject to the following two conditions:
1) this device may not cause interference, and 2) this
device must accept any interference, including
interference that may cause undesired operation of
the device.
Cet appareil est conforme avec Industrie Canada RSS
standard exemptes de licence(s). Son fonctionnement
est soumis aux deux conditions suivantes: 1) ce
dispositif ne peut causer des interférences, et 2) cet
appareil doit accepter toute interférence, y compris
les interférences qui peuvent causer un mauvais
fonctionnement du dispositif.
This radio transmitter 6982A-
0
has
YRHCPZW FM
been approved by Industry Canada to operate with
the antenna types listed below with the maximum
permissible gain indicated. Antenna types not
included in this list, having a gain greater than the
maximum gain indicated for that type, are strictly
prohibited for use with this device.
Le présent émetteur radio 6982A-
0
a
YRHCPZW FM
été approuvé par Industrie Canada pour fonctionner
avec les types d'antenne énumérés ci-dessous et
ayant un gain admissible maximal. Les types
d'antenne non inclus dans cette liste, et dont le gain
est supérieur au gain maximal indiqué, sont
strictement interdits pour l'exploitation de l'émetteur.
CAN ICES
NMB
-3B/
-3B
