P/N
-
-
Rev E
YRL KFTSINSTL FUL
16
Definitions
All Code Lockout Mode:
This feature is enabled by the Master code. When enabled, it restricts all user (except
Master)
code access. When attempting to enter a code while the unit is in Lockout, the
locked padlock
PIN
RED
will appear on the screen.
Automatic Re-lock Time:
After a successful code entry and the unit unlocks, it will automatically re-lock after
thirty (30) seconds.
Inside Indicator Light:
Located on the interior escutcheon. Shows active status (Locked) of lock and can be
enabled or disabled in the
(Main Menu selection #3).
Advanced Lock Settings
Language Setting Mode:
Choosing English (1), Spanish (2) or French (3) becomes the (default) setting for the
lock's voice prompts.
Low Battery:
When battery power is low, the Low Battery Warning indicator flashes
. If battery power is
RED
completely lost, use the 9Volt battery override. To use the 9V battery override apply 9V battery, in either direction,
to terminals below the touchscreen for backup power option. Wake up the lock and enter your pin code to unlock
the door.
Master
Code:
It must be created
PIN
The Master
code is used for programming and for feature settings.
PIN
prior to programming the lock.
The Master code will also operate (unlock/lock) the lock.
Network Module Setting:
With the optional Network Module installed, this setting becomes available thru the
Main Menu (7) and allows the lock to connect with a network controller.
One Touch Locking:
When the latch is retracted, activating the keypad will extend the latch (during Automatic Re-
lock duration or when Automatic Re-lock is disabled). When One-Touch Re-lock is
in use
any
not
(disabled),
valid
code will re-lock the lock.
PIN
Previous:
While in Menu Mode, pressing this icon cancels the current operation and returns the user to the
previous step.
Privacy Mode:
Privacy mode is disabled by default. Enable Privacy mode by pressing the privacy button for 4
seconds to put the lock in do-not-disturb mode (all pin codes are disabled).
Shutdown Time:
The unit will shutdown (flashing
) for sixty (60) seconds and not allow operation after the
RED
wrong code entry limit (5 attempts) has been met.
Tamper Alert:
Audible alarm sounds if attempting to forcibly remove outside lock from door.
User
Code:
PIN
The User code operates the lock. Maximum number of user codes is 250 with Network Module;
without Network Module, maximum is 25 user codes. Note: When deleting User
code(s), screen will display
PIN
User Number (not
code) being deleted.
PIN
Volume Setting Mode:
Low (2)
The volume setting for
code verification is set to
by default; otherwise it can
PIN
be set to
or
for quiet areas.
High (1)
Silent (3)
Wrong Code Entry Limit:
After five (5) unsuccessful attempts at entering a valid
code, the unit will shut
PIN
down and not allow operation.