Operation Settings: Setting the PIN
To change the Door Contact PIN code,
please enter the default PIN, ‘1,2,3’,
upon initial use.
If the red light is OFF, the PIN code was
successfully changed.
Enter the default code a second time and
the red light will flash. You can then proceed
with entering your unique 3 digit PIN code.
To arm your alarm simply press the "3"
button, then to disarm your alarm enter
your unique 3 digit PIN code.
PLEASE NOTE: If the unique code is entered incorrectly five times, the alarm will beep every two
seconds, 10 times and the key bindings will be locked for five minutes.
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
‘Press 1,2,3.’
1
2
3
PLEASE NOTE:
Don’t use the
number ‘3’ at the
beginning of your
unique PIN code.
❌
Factory Reset
Open the battery cover and take out the
battery, press and hold the learn button
and do not release whilst reinserting the
battery.
After three beep sounds, the Door Contact will
return to the default setting and the password
will restore to default ‘1,2,3’, the alarm will
be put into an unarmed state.
1
2
3
1
2
3
1
2
3
‘Enter your
unique
code’
PLEASE NOTE: If the red light flashes
three times, the PIN code change was not
successful.
‘3,X,X’
❌
7
