EN_Installation manual_Memo_v2.9
- 21 -
1.
To place the new heads all steps
must be followed backwards.
Master post:
1.
place the touchscreen and fasten it with
the M8x12 (100-233) bolts (4x). Apply
loctite adhesive right before fastening
the bolts to the touchscreen unit (see
page 13).
2.
connect the hat to the touchscreen with
the M8x20 (100-210) bolts (3x).
3.
connect the touchscreen with the yin
computer.
4.
connect the protection plate to the
frame of the master post with the
M8x20 (100-210) bolts (2x).
5.
5) connect the frontplate of the master
post by removing the M8x20 (100-210)
bolts (4x).
Basic post:
1.
connect the cable to the touchscreen.
2.
place the touchschreen unit to the steel
frame with the M8x10 (100-233) bolts
(4x). Apply loctite adhesive right before
fastening the bolts to the touchscreen
unit (see page 21).
3.
connect the hat to the touchscreen with
the M8x20 (100-210) bolts (3x).
4.
connect the speakercaps with the
M8x20 bolts (100-210) (2x).
2.
Connect the power plug when all the heads
are replaced. The heads must be callibrated
by holding the button for 20 seconds. The
startup proces can take up to 5 minutes.
Please look at the numbers of the post
if they are calibrated correctly. Double
check by playing the game ‘Runner’.
12 Installing new heads
